I am going to carve a lightweight, sculpted seat for my solo out of minicell foam.

Would like to get measurements of a few stock tractor seats to help me with dimensions on my project. (None of my boats have a tractor seat.)

So, if anyone would be willing to take a quick set of measurements, I am hoping to get: Width side-to side, length front-to-back, and perhaps a rough guess at height/depth of the seat as well. Might also help to know if it's a Wenonah, Sawyer, Swift, etc.

Final thought - do you wish yours were sized differently, and if so, how/why?

Thanks in advance!

This is the small/racing Wenonah seat:

14” wide, 11.5” front to back, center depth is about 1.5”

I covered mine with 0.25” thick foam for padding and slip resistance.

Excellent, thanks!

So does Wenonah make larger seats too?

The tractor seat on my Wenonah Spirit II:
width = 15.75 inches at its widest
length = 13.75 inches
depth = 2 inches at the rear (that is the deepest point
There is a 1 inch wide rolled edge along the sides and rear. That edge is included in the dimensions quoted above.