Boundary Waters Quetico Forum :: Gear Forum :: Need advice on replacing rivets in Wenonah imbedded plates
|
Author | Message Text | ||
nctry |
|
||
nooneuno |
|
||
bwcasolo |
wenonah canoe would be helpful. |
||
airmorse |
dcandta2014: "I need some advice from anyone who has experience in removing and replacing rivets in Wenonah canoes that use the imbedded aluminum plates. I assume you might use a bit stop to prevent drilling through the outside when removing the old rivets? Is the remaining rivet body left in the foam core or removed? I would contact Wenonah and ask them. Speak to customer service. They have been very helpful with my current project. Good Luck. |
||
dcandta2014 |
Very good information. I feel confident that I can get it done right thanks to you. If I find out any other tips, I will post. |
||
dcandta2014 |
What grip range do you use? Any experience you can share with this project would be greatly appreciated. Thank you very much. |
||
ORNonprophet |
When I ordered the new footbrace from them, it came with the 4 annodized aluminum rivets that I needed to do the job. They were/are 3/16ths rivet. Carefully drill the old ones out, the rivet head will come out on the bit and the rivet body will stay in the hole where they originally drilled through the aluminum backing plates embedded in the hull. I used a bit of blue masking tape on my 3/16ths drill bit to mark the depth (based on the length of the new rivet body) to make sure I didn't drill through the hull. Go slow when drilling and put down a towel to catch all the aluminum shavings that you'll make from drilling out the old rivets. I used 100% silicone to seal the old holes as the new track required different hole spacing. Even though you can probably re-use the same holes spacing-wise, I would recommend drilling new holes slightly apart from the old holes as there is really no way to fish out the remaining parts of the rivet that are between the aluminum plate and outside of the hull and when you push the new rivet into the old hole it could cause damage to the outer hull. I just used a standard Harbor Freight rivet gun--it did great. |
||
airmorse |
IF they are the same size rivets they should be 3/16 in size. So you'll need a new bracket and some 3/16 rivets. |