Boundary Waters Quetico Forum :: Group Forum: Boat Builders and Repair :: Varnish my Prism?
|
Author | Message Text | ||
Traveler |
As I was reading the fine print on the Epifanes can they recommend thinning 50% on the first coat, 25% on the second coat and 15% on the 3rd coat. This surprised me but I decided to proceed with their recommendations. The first coat made a huge difference. The color was much deeper and while not consistently shiny it does look nice compared to the before picture. This morning I put on a second coat. I find it quite difficult to accurately see the details and I won't be surprised to discover my own mistakes but I did take Tom's advice to heart and applied the varnish with a thin coat. So far I am happy. I will apply a final coat tomorrow. |
||
tumblehome |
Thinning varnish helps it flow/brush better and soaks into wood fibers. In your case it was not necessary but didn’t hurt either. So no harm, no foul. And following direction on the can is always a wise decision. See you on the water. Tom |
||
Traveler |
I have a 2007 Prism in very good condition. I want to give it back some shine. I have cleaned it well and lightly sanded. I purchased a can of Epifanes clear varnish, acetone for a light wipe down and foam roller and brush for application. Just before "going for it" I decided to contact Wenonah to make sure what my hull exactly is (my son purchased this for me and was told it is lightweight Kevlar) and to make sure I am not making a mistake by not applying epoxy first. I got an unexpected reply. First they apparently do not have records of hull builds going back past 2014. Secondly, they do not "recommend trying to refinish the bottom of a canoe. This rarely gives good cosmetic results and adds unnecessary weight without improving strength." They suggested possibly using a product they sell called Boat Guard Sealant. I think I will go ahead and apply the Epifanes. Your thoughts? Traveler |
||
Traveler |
|
||
Traveler |
|
||
tumblehome |
Gloss spar varnish will give you a shiny new surface over the canoe. It will hide many of the lighter scratches. It will add minimal weight, guessing at about 4oz. Clean everything off. Lightly sand with about 220 sandpaper to rough the surface. Clean again and apply the varnish in a warm dust-free work area. It takes several hours for spar varnish to harden enough to touch without leaving a finger print so keep your space dust-free for a while. You will probably need to add a second coat. Usually the gloss will not really come out until more than one coat is applied. If you don’t want a shiny surface, satin will give it less sheen. You will use more than a quart if you apply two coats. You need to sand very lightly with fine paper between coats. And you need to apply thin coats! IF you try to be a rockstar and apply a heavy coat to get it done in one fell swoop you will end up with runs in the varnish so don’t try to be a rockstar. Have fun! Tom |
||
mkdixon |
Mark |