Click to View the Full Thread

Author	Message Text
opolka	03/14/2015 02:51PM   Just set up a station similar to the one you described, and made strips out of 1x8 piece of redwood that I was given to me from a guy at work. It was so slick and easy! The strips are perfectly uniform. I set it all up on my strongback. I'll post some pics in my build thread but wanted to say thanks on this one for your tip. I've ripped wood on a tablesaw a lot. And was dreading the 1/4" from my experience ripping other somewhat thin items (nothing as small as 1/4" though). This went so much smoother then those other projects. Great idea Jim!
1JimD	03/14/2015 06:15PM   Glad you like the skilsaw method ! To me it's a NO BRAINER ! The uniformity is amazing !And that's what you need if you are building with bead and cove ! I'm setting up a new table for bead and cove. I post some pics that might be helpful. Great weather for building ! Jim
HighPlainsDrifter	03/14/2015 08:56PM   I used this method on my Ranger (the canoe build post is in here some time back). Excellent results almost ZERO waste. I first surface planed my wood, cut strips, and then beaded and coved. You should number your strips as you take them off each plank. That way you can do a perfect color match as you strip each side. Happy building Here are a few pictures of my set up:
1JimD	03/13/2015 05:47AM   I fasten the plank with a few finish nails. Very close to the edge, opposite of cutting. The best technic I've found, and the least expensive! Jim
opolka	03/12/2015 10:53PM   Thanks for sharing. Think I'm going this route. Do you just hold the board you are cutting? Or do you utilize clamps?
Rustycards	03/12/2015 09:38PM   Interesting! Thanks!
1JimD	03/12/2015 08:45PM   Here is a pic of my strip cutting skilsaw, and strongback. The saw setup was less than $100 including a great Feud 24t Advanti blade. The strips are so uniform, they don't need planning before I bead and cove them.