Click to View the Full Thread

Author	Message Text
HighPlainsDrifter	10/10/2015 08:27PM   Is there a trick on removing dried pine pitch from my hull without destroying the finish? I have tried mineral spirits and GooGone. Neither have touched the pitch.
HighPlainsDrifter	10/11/2015 09:43PM   Alan, I have 6 coats of Flagship spar varnish on my Merlin. I know I can't maintain a mirror finish on this canoe forever, but I think I will avoid acetone.
amhacker22	10/12/2015 07:23AM   I had a few isolated spots/drops at one point, and I was able to just kind of chip them off after the canoe had been in a freezing cold garage for a couple of months. This was coming off of a clear gel-coat, though, so I'm not sure it would do you a whole lot of good on varnish or if you have a lot of pine pitch. Maybe its worth a shot to play around with temperature a little bit before doing anything more drastic. Heat it up and hit it with the spirits again? Good luck!
Alan Gage	10/11/2015 04:46PM   quote HighPlainsDrifter: " Is there a trick on removing dried pine pitch from my hull without destroying the finish? I have tried mineral spirits and GooGone. Neither have touched the pitch." Acetone is my go-to chemical for removing paint. That's what I'd try. What kind of finish is on your boat? It won't damage epoxy, gel coat, or vinyl ester resin (used in most production boats) but it might remove the varnish if you've put any on. Alan
HighPlainsDrifter	10/12/2015 01:18PM   When all else fails, Google it. I did and found that Murphy's Oil Soap has been used on varnished surfaces. The recommendation was to let the product sit on the pitch for 15 minutes. I also read that WD-40 works. I am still looking for a response from someone who has cleaned a varnished wood canoe.
Cedarboy	10/13/2015 08:57AM   WD-40 will do the trick, wont harm finish. I have used it on my varnished strip canoes. CB
HighPlainsDrifter	10/13/2015 01:55PM   Thanks CB